External Serial ATA 1+1 Internal Port PCI Adapter

Add 1 Special External SATA Port and 1 Standard Internal SATA Port on your PC System to Support Mobile storage devices to transfer over 200 cm distance.

This card supports the Serial ATA (Generation 1) transfer rate of 1.5Gb/s (1500Mb/s).

This PCI Host Adapter can upgrade your desktop computer to have dual Serial ATA Channels. It can support Low profile PCI and regular size PCI slot both. The board provides a 32bit, 33/66 MHz PCI interface on the host side and dual, fully compliant Serial ATA ports on the device side to access Serial ATA mobile storage devices and standard media such as Hard Disk drive, floppy disk drive, CD-ROM, CD-RW, DVD, DVD-RAM, MO.

• Efficient driving capacity and right impedance to transfer over 200 cm External SATA cable KB-107
• One special SATA external connector for Mobile HDD, Mobile CD-ROM, Mobile DVD, Mobile CD-RW
• Provides 2 Brackets to Support Low profile PCI and Regular size PCI in one card
• 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB
• Dual high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s
• Fully compliant with Serial ATA 1.5G specifications 
• Supports Spread Spectrum in receiver
• Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes
• Compliant with PCI Specification, revision 2.2
• Integrated PCI DMA engines
• 32 bit, 33/66MHz fully compliant PCI host interface
• Completely with drivers for Windows 98, Windows Millennium, Windows NT 4.0, Windows 2000 and XP

Requirements :

• Pentium or equivalent PC with one available PCI slot
• Windows 98 / 98SE / Me / NT4.0 / 2000 / XP / Vista

Retail Package Content :

• External Serial ATA 1+1 Port PCI Adapter

• Driver Disk

• Quick Installation guide

• The solder used in this product contains lead, a chemical known to the State of California to cause birth defects and other reproductive harm. Please wash hands after handling internal components and circuit boards and avoid inhalation of fumes if heating the solder.